Lab 3: Part B
- Arva Syed
- Mar 19, 2020
- 1 min read
Updated: Mar 22, 2020
Lab 3: Part B
Unrolling
Form
Fall 2020
For this part of Lab 3 I unrolled all three of my figures using UnrollSrf. Then I duplicated the edges and borders. Then I used the grasshopper program for making tabs and dashed lines to make the gems ready for a laser cutter.
Here are the models:
To produce these gems I turned the vector lines into a PDF and printed the lines onto construction paper and used an exacto-knife to cut out the pieces. Then I used glue to assemble
Here are the gems:
Comments